Rear window defogger repair ! - Performance DIY by DIY Guru

Performance DIY by DIY Guru

Performance Diy is an automotive blog covering diy jobs from simple repairs,modifications to full restomod/restorations.If its on wheels its on Performance Diy

Sponser Leaderboard

 Fix your rear auto window defogger quickly and easily with an inexpensive repair kit. No special skills needed.

Repair a Rear Window Defogger

Repair broken electrical contacts

« Previous Photo
Last summer you loaded your SUV to the gills with antique furniture. You slammed the back hatch and off you went. Nothing was hitting the rear window before you left, or so you thought. But now that it's November and the temperature is tumbling, you notice the rear window defogger isn't working.
Checking the rear window, you realize that you broke off one of the electrical tabs for the defogger. Plus, one of the grid lines is scratched. There's no need to fork over the cash for a new window or pay someone to fix it. You can fix both of these problems yourself for less than $15.
Most auto parts stores stock rear window defogger repair kits. The two most popular are the Permatex Complete Rear Window Defogger Repair Kit No. 09117 and the Syon Rear Defogger Repair Kit No. 38-8434. The kits cost less than $20 and include repair instructions. If you only need to repair the tabs, buy the Loctite Rear Window Defogger Tab Adhesive No. 21351.
We selected the Permatex kit because it's widely available and is a complete kit for both repairs. The instructions aren't as consumer friendly as we'd like, but the kit performed flawlessly.
Even though the electrical tabs are soldered onto the defogger grid at the factory, avoid the temptation to solder the replacements. If the heat cracks the glass, you will have to buy a new window. Using the sandpaper from the kit, sand the rough solder surface on the loose tab (Photo 1). Use the alcohol prep to clean the tab and the grid area where the tab broke off (Photo 2). Then apply the activator to both areas and let it dry for two minutes. Next, knead the adhesive packet until the electrically conductive silver particles are fully mixed with the glue and apply the mixture to the tab (Photo 3). Press or tape the tab onto the activated grid area until it stays by itself (Photo 4).

Repair a broken grid line

To repair the grid line, simply attach the supplied stencil to the broken grid section and paint on the electrically conductive paint. Allow it to dry, then remove the stencil. You may want to touch up your work with a single-edge razor blade. But be careful. You don't want to damage any other grid lines.
We completed both repairs in less than 30 minutes. However, the instructions warned us to wait 24 hours to test the defogger. One last note: You can only do this repair when the temperature is above 50 degrees F.

No comments:

Post a Comment

Post Bottom Ad